Each Bulletpoint command center is unique and different. Sometimes, heavier devices need a little extra support or maybe your setup uses a longer arm. Whatever the case, our height-adjustable mounting arm support add-on may be exactly what you need!

Added Stability in Seconds

Reduce vibrations, add stability and clean up your setup. This Modular Height-Adjustable Mounting Arm Support is the perfect add-on for anyone running heavier devices or longer mounting arms. With stackable risers and a built-in charging cable channel, this modular support helps you fine-tune your dash mount for optimal performance and organization.

How it Works

This support system attaches to the center portion of any standard Bulletpoint mounting arm between the connector ends (4cm or longer). The base of the support rests directly on your dash or trim, taking the load off the arm and reducing unwanted movement especially when using heavier devices like tablets.

Each of the 5 risers stacks together and snaps into the included mounting arm clip, allowing you to set the height from 5mm (one riser) up to 25mm (all 5 risers). The clip also features a recessed channel so your charging cable runs neatly underneath the arm – no more dangling cords!

What's Included?

1x Mounting Arm Clip with integrated cable channel
5x Stackable 5mm Risers (total adjustable height: 5mm to 25mm)

Compatibility

This mounting arm support add-on works with all standard Bulletpoint mounting arms (4cm and longer). It is not compatible with Micro or Mini arms since the center sections are not long enough.

Pro Tip: It can be installed anywhere along the center section of the mounting arm but we recommend placing it closer to the device side.

Why You Might Need This!

If you’ve noticed your device bouncing or vibrating while driving especially over rough terrain, this support system is for you.

Stabilizes your device by adding a second point of contact with the mounting surface
Ideal for heavier devices or longer mounting arms
Helps prevent long-term wear on connector ends and mounting balls

Built-in Charging Cable Channel

The integrated cable channel in the arm clip keeps your charging cable neatly tucked away under the arm. This creates a cleaner, more organized dash setup and eliminates cable clutter.

For even more cable organization, pair it with our 7-piece Cable Management Kit.

Easy Installation

Snap 0 to 5 risers into the mounting arm clip to reach your desired height
Optional: Run your charging wire through the recessed channel
Slide the clip around the mounting arm
Ensure the base of the support rests on your dash or trim

No tools required. Everything snaps together securely for a solid & rattle-free fit.

Command Center Organization

Cable Management Kit

Height-Adjustable Mounting Arm Support Add-On with Charging Cable Channel

Multi-Purpose Hook and Loop Roll for Organization - 25 Feet Long x 1 Inch Wide

10-Piece Command Center Organization Bundle